PIC in Greek

STATUS ( Status register ) 03h,83h,103h,183h
By this register, the bank specification of the RAM file register, the time-out condition of the watchdog timer, the power down condition, the flag of the calculation result and so on, are managed.

The value in the parenthesis is in the condition immediately after the turning on.

IRP : In case of indirect addressing mode, the upper bit of the bank specification is set.

In case of indirect addressing mode, a bank is specified by the IRP bit and the highest bit of FSR.
An address in the bank is specified by lower 7 bits of FSR.

Because STATUS and FSR register are common to all of the banks, there is not hinderance in the operation even if the bank is switched over.

RP1,RP0 : The bank specification is set by these bits in case of direct addressing mode.

When specifying a register directly by an instruction, the bank is specified by RP0 and RP1.

RP1	RP0	Bank
0	0	0
0	1	1
1	0	2
1	1	3

TO(inv) : The time-out condition of the watchdog timer is set. It isn't possible to do writing.

	1	:	After power-on,CLRWDT instruction,or SLEEP instruction
	0	:	Watchdog time-out occurred

PD(inv) : A power down(power saving) condition is displayed. It isn't possible to do writing.

	1	:	After power-on or by the CLRWDT instruction
	0	:	By execution of the SLEEP instruction

Z : Zero bit

	1	:	The result of an arithmetic or logic operation is zero
	0	:	The result of an arithmetic or logic operation is not zero

DC : Digit carry/borrow(invert) bit (for ADDWF and ADDLW)

	1	:	A carry-out from the 4th low order bit of the result occurred
	0	:	No carry-out from the 4th low order bit of the result

C : Carry/borrow(invert) bit (for ADDWF and ADDLW)

	1	:	A carry-out from the most significant bit of the result occurred
	0	:	No carry-out from the most significant bit of the result occurred

FSR ( Indirect address register ) 05h,85h,105h,185h

This is the register to specify the address of the register with indirect address mode.
	The highest bit of FSR is used for the lower bit of the bank specification and a register address in the bank is specified by 7 bits of the remainder. The upper bit of the bank specification is specified by IRP of STATUS register. As for this, refer to the item of the STATUS register. As for the reading or writing of the register which was specified by FSR, refer to the item of the INDF register.

PORTn (Port register)/TRISn (Port mode set register) 85h,86h,87h,186h

PORTn register is the register which does data in or data out from/to the input/output port. TRISn register is a register to set a mode(in/out) of the port. In PIC16F873, the "n" is from A to C and there are not D and E. The A port is 6 ports (using lower 6 bits) and B and C are 8 ports.
	The input/output specification of each port is done with the TRISn register. In case of output, it is "0" and in case of input, it is "1". The data which was set to the PORTn register is output at once. The input data always appears at the PORTn register. The input data can be taken in if reading PORTn register.